+- Vandweller Forum (https://vandwellerforum.com)
+-- Forum: Vehicle discussion (https://vandwellerforum.com/forum-3.html)
+--- Forum: Passenger (https://vandwellerforum.com/forum-64.html)
+--- Thread: Miles Irving (/thread-838.html)
RE: Miles Irving - RepublicOfTXPatriot - 02-09-2018
(02-09-2018, 07:31 AM)GypsyDogs Wrote: You are absolutely welcome to buy a set for me and install them..
but seriously..
I do want to replace/upgrade my shocks..
I know it will NOT actually increase the load capacity of my van.. but it will help with wear/tear of carrying weight all the time.
IDK about the install. But I do have an extra set with brackets etc to fit a 1990's Ford truck chassis. I know they will fit between 1994 to 1997. The other benefit of the bags is that it will bring your rig back standard ride height. Therefore increasing handling, braking, fuel efficiency.
RE: Miles Irving - GypsyDogs - 02-09-2018
I'm pretty sure Miles is allergic to Ford parts..... LOL
RE: Miles Irving - Blacktank - 02-09-2018
(02-08-2018, 04:31 PM)Cammalu Wrote: Tx2sturgis isn't on this forum
Sent from my iPhone using Tapatalk
are your recruiting powers fading? or are we just to boring for him
RE: Miles Irving - GypsyDogs - 02-20-2018
So.. after spending a grueling week at 'shop-camp' Miles is back.
He was experiencing weird-freaky issue/s that I could not diagnose with my inadequate knowledge/tools.
Now he drives like a New van..
Put your foot down and he goes.. he doesn't have to think about it.. (they think the accelerator pump in the carb was faulty) (GS- remember the lack of fuel at camp?? may have been part of the issue)Starting sounds different now... hard to explain.. but some strange clicking when turned over.. Will continue to monitor.
Shop's work has a parts/labor guarantee and is backed by Napa and has been around about 20 years.. so not overly concerned...
I was also happy to hear my engine still 'talks' to me.. Scott may remember my mentioning that on our foray to town.. lol
On the non-mechanical side.. I got the kitchenette curtain done. And will likely use the scrap to make a cover for my fridge (along with reflectix and/or some insulation)
And came up with an idea for window insulation/light block.. will attempt and advise.
I really really really missed my van. Funny how, when you put so many hours into a project, it becomes like an extension of your body/mind...
ALSO- as soon as I finish up a couple more inside projects.. I will make a short Tour-Video (sans Bob- lol) and post.
RE: Miles Irving - Ballenxj - 02-20-2018
(02-20-2018, 07:09 AM)GypsyDogs Wrote: So.. after spending a grueling week at 'shop-camp' Miles is back.Glad to hear you got Miles back on the road. A bad accelerator could well have caused it to stumble when trying to go.
He was experiencing weird-freaky issue/s that I could not diagnose with my inadequate knowledge/tools.
Now he drives like a New van..
<-------->
ALSO- as soon as I finish up a couple more inside projects.. I will make a short Tour-Video (sans Bob- lol) and post.
Did you ask them about the clicking noise at the shop? Looking forward to the video.
RE: Miles Irving - GypsyDogs - 03-12-2018
Yeah Yeah.. been a while.. I know
got Miles out of the "shop"
He starts funny.. no "Voom." just "meh" but runs afterwards .. usually..
FINALLY had the opportunity to get the dog house off (been SUPER busy with life and adulting and shit..)
found This.
..Is it just me, or can I see at least 3 things wrong in this picture? (for clarity.. this is supposed to be a fresh rebuild-carb)
RE: Miles Irving - Blacktank - 03-12-2018
is that a cap that was on the bottom port there? that is where your pcv valve should be hooked to
RE: Miles Irving - RepublicOfTXPatriot - 03-12-2018
What Gary said. That port (which is still rusty dirty inside for a new rebuild) should have a hose attached to it going to the pcv valve (Positive Crankcase Vacuum (or Ventilation) valve.
RE: Miles Irving - RepublicOfTXPatriot - 03-12-2018
Does the vehicle have a vacuum advance on the distributor?
RE: Miles Irving - GypsyDogs - 03-12-2018
good guess.. but that hose is the other port.. on the pass.side. The one that is plugged is part of the (unused) heated air from the air filter system.