Thread Rating:
  • 2 Vote(s) - 4.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
FatvanSS Dragonwagon L.E.
i payed up for this one because it will carry some high amps and is under the hood exposed to some elements,if just carrying small amp inside you can pick up something cheaper

i've rewired more than one melted wiring harness so over building with larger wire and smaller fuses is what i do,when i was putting in my stereo i shorted it,the 10 amp glass fuse in the fuse box didnt blow,the 30 amp blade i added to the system did,fuses are not that reliable so go as small as possible or deal with melted wires
[-] The following 1 user says Thank You to Blacktank for this post:
  • AbuelaLoca (05-30-2020)
Reply
Nothing wrong with that.
You did get me thinking about building a couple with just 3/8" studs and I didn't upgrade my old busbars yet so.....if time becomes rare maybe a couple like yours...5 posts sounds better though , right ? Skuh kuh kuh kuh kuh kuh
And thx to Stern's research I won't be using stainless this time......
Stay Tuned
rvpopeye



Weirdo Overlord  YARC 
ROOIRIA  
15 "Stinkin'Badges"  a "Full Monty Badge" 2 "Just Ignore Me" clusters  10 "Pine Cone" clusters  , one "Stinkin' Badger" and 8 of the coveted "Flying Manure Spreader"awards
(What a "Stinkin' " honor !)
Reply
ethanol gel cleaned out of the carb,new fan clutch installed,all is well,except the skin on my left forearm

hopefully i finally fixed my startup belt squeal
Reply
i'm doing my best not to have mental block but twin bed is just narrow,only a couple inches to each side and when the leg falls over it scares me,a full would take up a lot of room,a futon? fold up to a couch,child guards on my bed? i know if i was force to use the twin i would make due but with a queen right upstairs...
Reply
Murphy bed is an option ???
Stay Tuned
rvpopeye



Weirdo Overlord  YARC 
ROOIRIA  
15 "Stinkin'Badges"  a "Full Monty Badge" 2 "Just Ignore Me" clusters  10 "Pine Cone" clusters  , one "Stinkin' Badger" and 8 of the coveted "Flying Manure Spreader"awards
(What a "Stinkin' " honor !)
Reply
i've ran it enough to confirm it was the frozen fan clutch that was making the belt squeal,hasnt even chirped since i changed it

i scraped away most of the enamel paint that was on my inner wheel well insulation and went to redo it with my flex seal liquid and it was no longer liquid,solid rubber,
Reply
Store the can upside down, the solvent vapor can't escape.
Stay Tuned
rvpopeye



Weirdo Overlord  YARC 
ROOIRIA  
15 "Stinkin'Badges"  a "Full Monty Badge" 2 "Just Ignore Me" clusters  10 "Pine Cone" clusters  , one "Stinkin' Badger" and 8 of the coveted "Flying Manure Spreader"awards
(What a "Stinkin' " honor !)
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)